Guntec USA AR10 .308 Stripped Billet Upper Receiver AR-10 These are the very popular DPMS Gen I Low Profile Pattern upper receivers. DPMS made Gen I in high or low profile. Gen II (aka small frame) is a recent development by DPMS. The Gen II are not well embraced by third party manufacturers at this time and there are very few handguards and lowers available on the market for it. - US Made In Scottsdale, Arizona
- Weight: 14.0 ounces
- MIL-A-8625 TYPE III Anodizing for Red and Black. FDE or ODGreen are Cerakoted. Silver is Raw Aluminum.
- 1913 Picatinny Rail Flat Top-DPMS Low Profile Rail Height
- Manufactured From Solid Block Of T6 6061 Billet Aluminum
- Will Match Up With Any Brand Gen I DPMS Pattern Lower Receiver
- Accepts Mil-Spec .308 Cal Ejection Port Door Kit And Forward Assist Kit (Not Included Unless Added)
- Slim Profile Shell Deflector
Upgrade Options - .308 Complete BCG for 7.62X51 Weight: 1.19 lbs
Nitride Treated HPT/MPI Tested and Marked 9310 Hardened Steel Bolt, 17-4 Stainless Steel Firing Pin (Heat treated to H900 Condition) 8620 carrier and gas key. Hardened extractor S7 tool steel. The group comes fully assembled with properly torqued and staked gas key Made in the USA
- .308 Upper Parts: Ejection Door Assembly and Forward Assist Assembly
- .308 Charging Handle
Finish Options GT-UPPER-308-RED Anodized Red Finish GT-UPPER-308 MIL-A-8625 TYPE III Anodizing GT-UPPER-308-FDE Cerakoted In Flat Dark Earth Finish (STRIPPED RECEIVER ONLY , SHOWN WITH GUNTEC HANDGUARD-SOLD SEPARATELY FOR EXAMPLE ONLY) GT-UPPER-308-R Raw, Unfinished
Available Options: |
Kit Options: |
|
Accessories: |
|
Color: |
|
Add Charging Handle : |
|
|